SRM9000 General Specifications |
Frequency Bands |
E0 66 - 88 MHz
AC 136 -174 MHz
KM 208 - 245MHz
R3 335 - 400 MHz
TU 400 - 480 MHz
UW 440 - 520 MHz
|
Channel Spacing |
10, 12.5, 20, 25kHz. / Channel
|
Frequency Stability |
+/- 2.5 ppm |
Power Requirements |
13.8Vdc, 7Amps |
Operating Temperature |
-30 to + 60 degrees centigrade |
Antenna Connector |
50 Ohm BNC |
Water and Dust Protection |
IP54, MIL810F |
Type Approval |
AS4295,
ETS300-086, ETS300-113
ETS300-279, ETS300-219
FCC, IC |
Transceiver |
56x170x165mm
1.8kg |
9010/9030 Microphone |
82x57x38mm
200g |
9020 Microphone |
96x68x44
200g |
9022 Handset |
170x66x28mm
200g |
9030 Control Head |
65x188x45mm
210g |
SRM9000 Transmitter Specifications |
Output Power |
1, 2, 2.5, 4, 5, 6, 8, 10, 15, 20,
25W
2 power levels programmable. |
Duty Cycle |
1min Tx : 4min Rx |
Audio Distortion |
less than 3% @ 1000Hz, 60% dev |
Audio Frequency Response |
+1/-3dB of pre-emphasised
300Hz to 3000Hz on 25kHz Ch
300Hz to 2550Hz on 12.5kHz. |
Hum and Noise |
>40dB (12.5kHz channel)
>45dB (25kHz channel) |
Transmitter On Time |
less than 25mS |
|
|
SRM9000 Receiver Specifications |
Sensitivity |
0.30uV for 12dB SINAD |
Selectivity |
>73dB (25kHz channel)
>63dB (12.5kHz channel) |
Intermodulation |
>65dB (ETS method) |
Audio Frequency Response |
+1/-3dB of pre-emphasised
300Hz to 3000Hz on 25kHz Ch
300Hz to 2550Hz on 12.5kHz. |
Blocking |
>95dB at +/- 1MHz |
Hum and Noise |
>40dB (12.5kHz channel)
>45dB (25kHz channel) |
Audio Output Power |
4W into 4 ohms
or link for 10W into 8 ohms |
Audio Distortion |
less than 5% at 4W |
|
|
Standards and Conformance Marks |
|
ETS300-086 Radio
ETS300-113 Data
ETS300-279 EMC
ETS300-219 Sig |
|
AS4295 Aust
|

|
European Conformance Mark
|

|
E - Mark |

|
Australian Conformance Mark
|