Portable - Specifications

 

SRP9100 General Specifications
Frequency Bands	E0  66 - 88 MHz AC 136 -174 MHz KM  208 - 245MHz R3  335 - 400 MHz TU  400 - 480 MHz UW 440 - 520 MHz
Channel Spacing	12.5, 20, 25kHz. 10kHz  Optional.
Modulation	Pre-emphasised FM
Power Requirements	NiCad Battery 7.2V 1600mAh NiMH Battery 2100mAh  NiMH Battery 2700mAh  Li-Ion Battery 3000mAh
Duty Cycle	>13 hours, high transmit power, 3000mAh battery, 90:5:5 duty cycle.
Operating Temperature	-30 to + 60 degrees celcius
Antenna Connector	50 Ohm SMA (female plug)
Water and Dust Protection	IP54
Type Approval	EN 300086, EN 300113, EN300219, EN 301489, AS4295 FCC, IC
Dimensions	147(H) x 68(W) x 46(D)mm
Weight	430g (with Li-Ion battery +antenna)

  

SRP9100 Transmitter Specifications
Output Power	0.5, 1, 2, 2.5, 4, 5W 2 power levels programmable.
Audio Distortion	less than 3% @ 1000Hz, 60% dev
Audio Frequency Response	+1/-3dB of pre-emphasised 300Hz to 3000Hz on 25kHz Ch 300Hz to 2550Hz on 12.5kHz.
Hum and Noise	>40dB (12.5kHz channel) >45dB (25kHz channel)
Transmitter On Time	less than 25mS

  

SRP9100 Receiver Specifications
Sensitivity	0.30uV for 12dB SINAD
Selectivity	>73dB (25kHz channel) >65dB (12.5kHz channel)
Intermodulation	>65dB (ETS method)
Audio Frequency Response	+1/-3dB of pre-emphasised 300Hz to 3000Hz on 25kHz Ch 300Hz to 2550Hz on 12.5kHz.
Blocking	>95dB at +/- 1MHz
Hum and Noise	>40dB (12.5kHz channel) >45dB (25kHz channel)
Audio Output Power	500mW into 16 ohms
Audio Distortion	less than 5% at 500mW

 

SRP8000 General Specifications
Frequency Bands	66 - 88 MHz 138 -174 MHz 335 - 375 MHz 403 - 440 MHz 440 - 470 MHz
Channel Spacing	12.5, 20, 25kHz.
Frequency Stability	2ppm
Modulation	Phase (speech); Frequency (data)
Power Requirements	NiCad Battery 7.2V 1600mAh NiMH Battery 2100mAh
Operating Temperature	-20 to + 55 degrees centigrade
Antenna Connector	50 Ohm SMA (female plug)
Water and Dust Protection	IP54
Type Approval	ETS300 086 Radio; ETS300-113 Data; ETS300 279 EMC; ETS300 219 Sig; AS4295-1995
Dimensions	147(H) x 68(W) x 46(D)mm
Weight	485g (with battery and antenna)

  

SRP8000 Transmitter Specifications
Output Power	Low: 1W High: 4-5W (band dependant)
Modulation Distortion	less than 5% @ 1000Hz, 60% dev
Modulation Response	+1/-3dB of pre-emphasised 300Hz to 2.55kHz on 12.5k channel.
Hum and Noise	>40dB (12.5kHz channel)
Transmitter On Time	less than 25mS

  

SRP8000 Receiver Specifications
Sensitivity	0.3uV for 12dB SINAD
Selectivity	>70dB (25k channel) >60dB (12.5k channel)
Intermodulation	>65dB (ETS method)
Spurious Response Attenuation	70dB
Audio Output Power	500mW into 8 ohms
Audio Distortion	less than 5% at 500mW

   

Standards and Conformance Marks
	ETS300-086 Radio ETS300-113 Data ETS300-279 EMC ETS300-219 Sig
	AS4295 Aust
	European Conformance Mark
	Australian Conformance Mark
	FCC and IC

 Top